TB 11-5830-263-20-12
VIS CABLING INSTALLATION
Note
Where possible, run VIS cables along existing vehicle cable paths. Use
existing cable clamps to hold VIS cables in place. If cable clamps are
not large enough to hold VIS cables and vehicle cables, tie wrap VIS
cables to clamped vehicle cables using tiedown straps supplied with kit,
as required. During installation, leave tiedown straps loose enough to
adjust cable slack and allow for easy adjustment of equipment. When
installation is complete, tighten and secure tiedown straps.
WARNING
MAKE SURE VEHICLE POWER SOURCE IS POSITIONED OFF OR
DISCONNECTED BEFORE INSTALLING CABLES.
a. MCS, Commander and Rear Crewmember FFCS Cabling Installation (Fig. 4-6)
1.
Secure connector P1 of the Radio R/T Cable Assembly (8) to the Radio A
connector on the MCS (11).
2.
Route the Radio R/T Cable (8) as shown in Figure 4-6, until the Radio
Mounting Tray is reached.
3.
Secure connector P2 of the Radio R/T Cable Assembly (8) to the Radio
Mounting Tray connector A4J3.
4.
Secure connector P1 of the Power Cable Assembly (9) to the Power
connector on the MCS (11).
5.
Radio Mounting Tray is reached.
6.
Secure connector P2 of the Power Cable Assembly (9) to the Radio
Mounting Tray connector A4J2.
7.
Secure connector P1 of the Loudspeaker Cable Assembly (4) to the
Loudspeaker connector on the MCS (11).
8.
Route the Loudspeaker Cable Assembly (4) as shown in Figure 4-6, until
the Loudspeaker (7) is reached.
9.
Secure connector P2 of the Loudspeaker Cable assembly (4) to the
connector on the Loudspeaker (7).
10.
Secure connector P1 of the Highway Cable Assembly (2) to the top Station
connector on the MCS (11).
11.
Route the Highway Cable Assembly (2) as shown in Figure 4-6, until the
Commander's FFCS (12) is reached.
12.
Secure connector P2 of the Highway Cable Assembly (2) to the right side
Station connector of the Commander's FFCS (12).
13.
Secure connector P1 of the Highway Cable Assembly (1) to the left Station
connector of the Commander's FFCS (12).
14.
Route the Highway Cable Assembly (1) as shown in Figure 4-6, until the
Rear Crewmember's FFCS (13) is reached.
15.
Secure connector P2 of the Highway Cable Assembly (1) to the right side
Station connector of the Rear Crewmember's FFCS (13).