CLR (clear) button.
Clears data from keyboard display If an error was made during an entry or If data needs
to be cleared from RT memory.
H-Ld (hold-load) button.
Used to load data into holding memory and to retrieve data from permanent memory
into holding memory. Refer to glossary In the back of this manual for information on
holding and permanent memories.
Sto/ENT (store/enter) button. Used for data loading. Transfers data from RT holding memory into permanent
memory. Operator presses Sto to put ERF from NCS into RT permanent memory (in
BATT (battery) button.
Used to check and set battery life condition in manpack radio. When pressed, display
shows remaining amount of battery life. Refer to the battery life condition diagram on
CALL (call) button.
Used with future equipment.
Used to enter numerical data such as SC frequencies, position In which data is to
bestored, battery life condition, etc.