SPEC TASK 6:
Conduct RXMT Operations :
Used when one or more net stations are out of normal SINCGARS
range, or an obstacle blocks line of sight communications. (SEE
SPEC TASK 7:
Send an ERF as Part of RXMT Operation:
Used during RXMT operations when required to establish initial
contact with distant station
SPEC TASK 8:
Change Net ID:
Used when contact with a non-loadset station is desired. Operator
changes one, two, or all three digits of the net ID.
SPEC TASK 9:
Use SIP/ASIP RT as an RCU:
Used when remote control of a radio is required. A SIP/ASIP RT
cannot be used in an RCU configuration when HRCRD is being used
SPEC TASK 10:
Send Data Via RS-232 Mode :
Used when data message is to be sent from one computer to
another over a SINCGARS net using a commercial program
containing widely used Xmodem" file transfer protocol.
*NOTE: DATA RXMT: All date rates except PCKT may be RXMT
with the following provisions.
SDM data, TF and AD1: No change to normal RXMT procedures. Radios do not
have to be set in Data mode (data off). Mixed radios at RXMT site or outstations is
EDM Data: Radios at the RXMT site have to be set to the same EDM data rates as
outstations. ONLY SIP radios can be used at the RXMT site and outstations.