TM 11-5820-890-30-4
3-27. REPLACEMENT OF CONNECTORS. Continued
c. Replacement of Six-pin Audio Connectors (J13, J14, and J18).
ITEM
ACTION
REMARKS
REMOVAL
a. Spanner nut (7A)
b. Wires and pins
c. Connector (7)
INSTALLATION
d. Wires and pins
e. Connector (7)
f. Spanner nut (7A)
Use 3/4-inch spanner wrench. Remove
and retain spanner nut from audio con-
nector (7). See figure 3-12 (sheet 1),
Remove connector from test adapter.
Note positions of wires connected to
audio connector. Use soldering kit. De-
solder wires from pins on connector.
Discard.
Use soldering kit. Solder wires to correct
Before and after soldering,
pins on connector.
clean solder joints with cot-
ton swabs and alcohol.
insert replacement connector in test
adapter with correct orientation.
Use 3/4-inch spanner wrench. Install and
This was removed in
tighten spanner nut on connector.
step a.
3-96