4-40. REPLACEMENT OF BOTTOM COVER.
Cross tip screwdriver
a. Mounting adapter
b. Bottom cover (13)
c. Gasket (14)
d. Gasket (14)
e. Bottom cover (13)
Set upside down on work surface with
power supply chassis toward you.
Using cross tip screwdriver, remove and
See figure 4-11.
retain 18 screws (11) and flat washers
(12) securing defective bottom cover
(13) to power supply chassis (15).
Remove bottom cover.
Remove and inspect gasket (14), replace
gasket if required. Discard bottom
Position retained gasket (14) to
This was removed in
replacement bottom cover (13).
Using cross tip screwdriver, install 18
These were removed in
retained screws (11) and flat washers
(12) securing bottom cover (13) to
power supply chassis (15).