TM 11-5820-890-30-4
6-24. REPLACEMENT OF CONTROL-MONITOR MODULES.
Tools:
Flat tip screwdriver
Torque screwdriver
Module extractor
References:
Paragraph 6-20 for use of module extractor.
Paragraph 6-22 for removal and installation of back cover.
Figure 6-9 for location of modules.
ITEM
ACTION
REMARKS
REMOVAL
a. Back cover
b. Module
c. Module
INSTALLATION
d. Module
e. Module
f. Back cover
Remove and retain.
Refer to paragraph 6-22 for
removal instructions.
Hook module extractor to module using
Refer to paragraph 6-20 for
two holes in top corners of circuit card.
use of module extractor,
and figure 6-9 for location
of modules.
Pull free of control monitor.
Place module in card guides.
Press down to fully seat circuit card.
Install on control-monitor chassis.
Refer to paragraph 6-22 for
installation instructions.
Figure 6-9. Control-Monitor Module Locations.
6-48