8-17. REPLACEMENT OF BINDING POSTS.
Flat tip screwdriver
5/16-inch open end wrench
Access cover (27)
Use flat tip screwdriver. Fully loosen five
captive screws (31). Remove cover to
Use soldering kit. Tag and desolder three
wires from terminals of two-wire transient
protection CCA (26).
Two-wire transient protec-
tion CCA (26)
Use soldering kit. Desolder bus wires from
defective binding post (28).
Use cross tip screwdriver. Remove and
retain four screws (9), Iockwashers (8),
and flat washers (7) securing CCA to
Binding post (28)
Use 5/16-inch open end wrench. Remove
and retain nut, Iockwasher, and flat wash-
er securing defective binding post to ac-
cess cover. Remove and discard defect-
ive binding post.
f. Binding post (28)
Position replacement binding post to ac-
cess cover. Use torque wrench and 5/16-
inch socket. Install retained nut, lockwash-
er, and flat washer securing binding post
to access cover. Torque nut to 5 to 7 in-lb.
This was removed in
h. Two-wire transient
protection CCA (26)
Position retained CCA to access cover.
Use cross tip screwdriver. Install four re-
tained screws (9), Iockwashers (8), and
flat washers (7) securing CCA to access
These was removed in
Before and after soldering,
clean wires and solder
joints with alcohol and
Use soldering kit. Position and solder bus
wires to binding post (28).
i. Bus wires
Use soldering kit. Position and solder three
tagged wires to terminals E1 thru E3 of two
wire transient protection CCA.