13-23. REPLACEMENT OF P1 CONNECTOR.
Flat tip screwdriver
Power supply adapter
Set on work surface with rear toward
you. See figure 13-4.
12 captive screws (3)
Use flat tip screwdriver. Fully loosen
and inspect for damage. If damaged,
Rear access cover (2)
Remove from chassis to allow access to
PI connector, and retain.
d. Four screws (10)
Use flat tip screwdriver. Remove and
inspect four screws securing connector
to rear access cover. If damaged,
Remove from rear access cover and
inspect for damage. If damaged, obtain
Connector (9) wires
Tag the location of all wires on defective
connector. Use soldering kit. Desolder each
wire from the connector.
Remove and discard defective connector.