TM 11-5820-890-30-4
15-17. REPLACEMENT OF FILTER EMI-CCA. Continued
ITEM
ACTION
REMARKS
INSTALLATION Continued
h. FILTER EMI-CCA wire
Use soldering kit. Solder wires to correct
NOTE
terminals of FILTER EMI-CCA.
Before and after soldering,
clean wires and terminals
with cotton swabs and
alcohol.
i. Screw (19) and
Use cross tip screwdriver, Install and
Iockwasher (18)
hand tighten screw (19) and Iockwasher
(18) securing terminal lug (17) to FILTER
EMI-CCA.
j. Eight screws (5)
Use cross tip screwdriver. Install and
and Iockwashers (6)
hand tighten eight screws (5) and
Iockwashers (6) securing access
cover (1) to connector case (12).
Use torque screwdriver. Torque
screws to 8 to 10 in-lb.
If a screw is not stripped
but will not tighten, refer
to paragraph 15-16 for
replacement of its threaded
screw insert (if present),
If a tapped hole is defec-
tive, refer to paragraph
15-10 for replacement of
the connector case. (12).
Section V. PREPARATION FOR STORAGE OR SHIPMENT
15-18. GENERAL INFORMATION.
Pack the electrical connector assembly (9A1) in an approved shipping container.
15-22
