TM 11-5820-890-30-4
Section Il. REPAIR PARTS,
AND SUPPORT
3-9. COMMON TOOLS AND EQUIPMENT.
SPECIAL TOOLS, TMDE,
EQUIPMENT
For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment (MTOE)
applicable to your unit.
3-10. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT.
For the TMDE and support equipment required for DS, see the maintenance allocation chart. It is Appendix B in
TM 11-5820-890-20-1.
3-11. REPAIR PARTS.
Repair parts are listed and illustrated in the repair parts and special tools list (TM 11-5820-890-30P-1) covering
direct support maintenance for this equipment.
Section Ill. SERVICE UPON RECEIPT
3-12. CHECKING UNPACKED EQUIPMENT.
a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged,
report the damage on DD Form 6, Packaging Improvement Report.
b. Check the equipment against the packing slip to see if the shipment is complete. Report all
discrepancies in accordance with the instructions of TM 38-750.
c. Check to see whether the equipment has been modified.
3-13. ASSEMBLY AND INSTALLATION OF STANDARD TEST SETUP.
The reference fixture and mounting base can be secured to a work bench. This may be desirable for some
installations. A 12-ft power cable is provided. A 28 V dc power source must be provided by the user. The
following procedure describes a typical installation.
CAUTION
Steps marked with must be performed exactly as written. They are critical in maintaining
the nuclear hardness of the mounting adapter. Seals must not be damaged. All screws must be
torqued to the limits specified in the replacement procedures.
ITEM
ACTION
REMARKS
a. Mounting base
Set on work surface.
Attaching hardware is
Secure to work surface if desired.
provided with the mount.
See figure 3-5.
Position must be within 12
Remove protective caps from
feet of power source
connectors J1 and J5.
(22 to 32 V dc).
Connect to mounting base
connector J1 and power source.
b. Cable CX-4720/VRC
3-20
