TM 11-5820-890-30-4
3-27. REPLACEMENT OF CONNECTORS. Continued
b. Replacement of Circular Multipin Connector J11.
ITEM
ACTION
REMARKS
REMOVAL
a. Four screws (2), nuts (5),
Use #1 point cross tip screwdriver and
flat washers (4), and
7/32-inch nutdriver. Remove and retain
spacers (2A)
four screws, nuts, flat washers, and
spacers securing connector J11 (3) to
test adapter. Remove connector J11 from
test adapter. See figure 3-12 (sheet 1).
b. Wires and pins
Use soldering kit and pin insertion/
Before and after soldering,
removal tool included in connector pack-
clean solder joints with cot-
age. Remove any damaged pins from
ton swabs and alcohol.
connector (3). Desolder pins from
wires and solder new pins on wires.
INSTALLATION
c. Pins
Use pin insertion/removal tool. Remove
remaining pins one at a time from bad
connector and install all pins in correct
positions in replacement connector.
d. Connector (3)
Insert connector in test adapter with
correct orientation.
e. Four screws (2), nuts (5),
Use #1 point cross tip screwdriver and
These were removed in
flat washers (4), and
7/32-inch nutdriver. Insert four retained
step a.
spacers (2A)
screws through connector and test adapt-
er. lnstall and tighten screws with four
retained flat washers, spacers, and nuts.
3-95
