TM 11-5820-890-30-4
4-34. REPLACEMENT OF DIODE CR1. Continued
ITEM
ACTION
REMARKS
INSTALLATION
f. Diode CR1 (20)
g. Two screws (22), flat
washers (24), and
Iockwashers (23)
h. Wires
Rear access
i.
cover (12)
Position replacement diode CR1 (20) to
mounting bracket (21). Using 7/16-inch
open-end wrench, install retained hex nut
(26) and Iockwasher (25) securing diode
CR1 (20) to mounting bracket.
Using cross tip screwdriver, install
mounting bracket (21) to power
control chassis (17) using two retained
screws (22), flat washers (24), and
Iockwashers (23).
Using soldering kit, solder tagged wires
to terminal on diode CR1 (20). Remove
wire tags. Replace insulation sleeving
as required.
Hold in place and tighten six captive
screws (13) securing rear access cover
(12) to power control chassis (10).
Using torque screwdriver, torque screws
to 8 to 10 in-lb.
This was removed in
step e.
These were removed in
step d.
Before and after soldering,
clean wires and terminal
with alcohol and cotton
swabs.
See figure 4-5.
This was removed in
step b.
4-130
