TM 11-5820-890-30-4
8-24. REPLACEMENT OF BATTERY BOX CASE. Continued
ITEM
ACTION
REMARKS
INSTALLATION Continued
NOTE
Ensure single keyway is
located to right of raised
letters.
P1 connector (6)
Use cross tip screwdriver, Position connec-
tor to case. Install four retained screws
(9), Iockwashers (8), and fiat washers (7)
securing connector to case.
q.
Terminal lug (17)
Use cross tip screwdriver. Position termi-
nal lug to case. Install retained screw (9),
Iockwasher (8), and flat washer (7) secur-
ing terminal lug to case.
These were removed in
step i.
r.
J1 connector (34)
Install.
Refer to paragraph 8-18 for
installation instructions.
NOTE
Before and after soldering,
clean wires and terminals
with alcohol and cotton
swabs.
This was removed in
step g.
s.
Two-wire transient
protection CCA (26)
Use soldering kit. Position and solder
three tagged wires to terminals E1 thru
E3.
t.
Use torque screwdriver. Install and tighten
five captive screws (31) securing access
cover to case. Torque screws to 5 in-lb.
Access cover (27)
Catch assemblies (18)
Strikes (23) and (14)
u.
v.
Install.
Refer to paragraph 8-14 for
installation instructions.
These were removed in
step b.
Use cross tip screwdriver. Position retain-
ed strikes to case. Install four retained
screws (11), Iockwashers (12), and flat
washers (13) securing Strikes to case.
w.
Battery box cover (1)
Two battery box cover
Position on case.
This was removed in
step c.
x.
y.
Fasten two twist lock latches securing bat-
Iatches (32)
tery box cover (1) to battery box case (15).
Section V. PREPARATION FOR STORAGE OR SHIPMENT
8-25. GENERAL INFORMATION.
Pack the battery box in an approved shipping container.
8-21
