TM 11-5820-890-30-4
Section Ill. TROUBLESHOOTING
Subject
PROCEDURES
Para
Page
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11-5
11-2
Operational Check . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 1-6
11-2
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..11-7
11-4
11-5. GENERAL.
This section provides the troubleshooting procedures used to isolate a defective CX-13313/VRC cable. There is
no troubleshooting information as the CX-13313/VRC cable is a nonrepairable item.
11-6. OPERATIONAL CHECK.
The operational check provides a step-by-step procedure for evaluating a CX-13313/VRC cable. lf the opera-
tional check is passed, the CX-13313/VRC cable can be returned to service. If it does not pass the test, the
CX-13313/VRC cable shall be considered bad.
The operational check is divided into steps. Each step verifies a particular function. Follow the instruction in the
Action column. Check the response. If the response is correct, proceed with the next lettered step. When a
Step has been completed, proceed with the next Step. A "No response" in the "Response" column means that
any response is not of interest.
The switch settings for the test equipment are given in the "EQUIPMENT PRESETS" section of each test setup
figure.
WARNING
Connect the test setups only when directed, and with the power supply set to OFF. The large
current capacity of the test power supply can cause personal injury. Verify the test setup before
turning the power supply ON.
11-2