REPLACEMENT OF J2 CONNECTOR.
Flat tip screwdriver
Socket wrench spanner attachment
1 5/16-inch spanner wrench
Power supply adapter
Set on work surface with rear toward
you. See figure 13-4.
b. 12 captive screws (3)
Use flat tip screwdriver. Fully loosen and
inspect for damage. If damaged, obtain
Rear access cover (2)
Remove from chassis to allow access to
J2 connector (1), and retain. See figure 13-5.
d. Spanner nut
Use 1 5/16-inch spanner wrench. Remove
and inspect spanner nut securing connec-
tor to power supply adapter chassis. If
damaged, obtain replacement.
Connector (1) and
Remove and discard defective connector
Connector (1) wires
Tag the location of all wires on defective
connector. Use soldering kit. Desolder each
wire from the connector.