TM 11-5820-890-10-1
HOPSET. Check the SOI for required hopsets.
a. Make sure that the ECCM fill device Is loaded.
If the ECCM fill device needs to be filled, see Chapter 4.
b. Set ECCM fill device function switch to OFF.
CAUTION
DC NOT CONNECT FILL DEVICE DIRECTLY TO RADIO AUD/FILL CON-
NECTOR. CONNECTOR DAMAGE MAY OCCUR IF FILL CABLE IS NOT
USED.
c. Connect ECCM fill device to RT connector AUD/FILL using fill cable.
d. Set RT FCTN to LD.
e. Set RT MODE to FH, CHAN to normal operating position.
f, Set ECCM fill device select switch to position containing the hopset.
g. Set ECCM fill device function switch to ON.
h. Press LOAD. Display cycles
as shown, and a beep is
heard.
i.
Press STO. Display shows
" S T O " .
j.
Enter the number of the channel
in which the hopset Is to be
stored (1 - 6). Display blinks
and shows "STO" followed by the
channel number in which the hop-
set was stored.
If additional hopsets are to be
loaded, repeat steps a thru j for
each.
k. Set ECCM fill device function
switch to OFF.
l.
Disconnect ECCM fill device
from rt connector AUDIFILL.
m. Set RT switches as needed for
normal operation.
3-4
