TM 11-5820-890-10-3
LOADING FH DATA (LOCAL FILL) Continued
LOADING FH DATA. Check with NCS or SOI for required FH data.
ECCM Fill Device Connected to RT
a.
Make sure that the ECCM fill device is loaded.
b.
Set ECCM fill device function switch to OFF.
CAUTION
ALWAYS USE A FILL CABLE TO CONNECT FILL DEVICE TO RT. EQUIPMENT DAMAGE MAY
RESULT IF A FILL CABLE IS NOT USED.
c.
Connect ECCM fill device to RT connector AUD/FILL using fill cable.
d.
Set RT FCTN to LDV.
e.
Set RT MODE to FH.
f.
Set CHAN to MAN.
g.
Set ECCM fill device select switch to T1 or T2.
h.
Set ECCM fill device function switch to ON.
i.
Press HLd. Display will show "Load", then, "Sto t". A beep Is heard; then "Cold" Is displayed.
j.
Set FCTN to LD.
k.
Set ECCM fill device function switch to OFF.
I.
Disconnect ECCM fill device from RT connector FILL.
m.
Set MODE to SC. Display will show MAN frequency, "XXXXXX".
n.
Set MODE to FH. Display will show "Cold" (ready for ERF from NCS).
NOTE
Same procedure applies when changing FH data for during operation updates using a fill device.
2-37
