POCKET GUIDE
TM 11-5820-890-10-7
Special Task 9:. Use SlP/ASlP RT as an RCU
STEP
1
2
3
4
5
6
ACTION
RESULT
Load RT &. RCU(RT) with
Prepares SIP RTs for remote
proper data
operations’
Install wire link from
(See TM 11-5820-890-10-6
RCU(RT) to Rem radio
for setup instructions)
Set Rem RT FCTN switch
Enables RCU(RT) to control
to REM position
Rem radio
Set RCU(RT) FCTN
(LD, SO OFF, and RXMT may
switch to SQ ON
also be used)
Set RCU(RT) DATA to any
N/A
option
Press [ RCU] key on
‘RT,” ‘RCU,” ‘EXT.” and
RCU(RT); select ‘RCU”
‘LDE” show in RT display
Wait 7 sec; then note
SIP RT is now ready to
RCU(RT) display Mink
perform as an RCU(RT)
Set RCU(RT) FCTN to
Enables RCU(RT) Opr to call
REM position
remote radii by wire
Press RCU(RT) CALL key
Produces ring tone and CALL
& PTT at same time; hold
message at Rem RT; oprs can
for 4 to 7 seconds
talk on orderwire
Set RCU (RT) FCTN to SQ
Remoted radio is now
ON
controlled by RCU(RT)
For use of a SIP RT as either a manpack RCU or a manpack remoted
radio, Battery Box CY-8523A/B is required. ASIP requires a two wire
adapter.
** RCU, C-11561, may be used for remote control of a SIP radio for
voice and SDM data only, not for EDM data.
*** RCU(RT) COMSEC must be set to PT to talk over orderwire.
3
7
