TM 11-5820-890-30-4
Section Il. REPAIR PARTS, SPECIAL TOOLS, TMDE,
AND SUPPORT EQUIPMENT
Subject
Para
Page
Common Tools and Equipment
. . . . . . . . . . . . . . . . . . . . . . . . .
17-3
Special Tools, TMDE, and Support Equipment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17-4
Repair Parts
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
17-5
17-3. COMMON TOOLS AND EQUIPMENT.
7-2
7-2
7-2
For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment (MTOE)
applicable to your unit.
17-4. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT.
For the TMDE and support equipment required for DS, see the maintenance allocation chart. It is Appendix B in
TM 11-5820-890-20-1.
17-5. REPAIR PARTS.
Repair parts are listed and illustrated in the repair parts and special tools list (TM 11-5820-890-30P-1) covering
direct support maintenance for this equipment.
Section Ill. TROUBLESHOOTING PROCEDURES
Subject
Para
Page
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17-6
17-2
Operational Check . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17-7
17-2
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . . . . 17-8
17-6
17-6. GENERAL.
This section provides an operational check to verify if an MX-18290/VRC is defective. Defective fill devices are
sent to general support for repair.
17-7. OPERATIONAL CHECK.
The operational check provides a step-by-step procedure for evaluating an MX-18290/VRC. If the operational
check is passed, the MX-18290/VRC can be returned to service. If it does not pass the check, the
MX-18290/VRC shall be considered bad.
The operational check is divided into steps. Each step verifies a particular function. Follow the instruction in the
“Action” column. Check the response. If the response is correct, proceed with the next lettered step. When a
Step has been completed, proceed with the next Step. A “No response” in the” Response” column means that
any response is not of interest. If a test response is incorrect, check the equipment settings and the test setup
cabling.
Connect equipment as shown in figure 17-1 to perform the operational check of the MX-18290/VRC.
17-2
