TM 11-5820-890-30-4
17-7. OPERATIONAL CHECK. Continued
Step 2. LOADING FH DATA (LOCAL FILL) INTO RT (RECEIVER-TRANSMITTER).
Action
Response
a. Prepare RT for operation.
a. Make sure that the fill device is loaded.
If the fill device needs to be filled, see
Step 1 on page 17-3.
b. Set fill device FUNCTION switch to OFF
b. No response.
position.
c. Connect fill device connector J1 to RT
c. No response.
AUD/FILL connector using fill cable, as
shown in figure 17-2.
d. Set RT FCTN switch to LD,
d. No response.
set MODE switch to FH, and
set CHAN switch to position where
FH data is to be loaded.
e. Set fill device FUNCTION switch to ON, and
e. No response.
set SELECT switch to position containing
FH data.
f. Press LOAD key and then STO key on RT
f. RT display will cycle as shown, and a
keypad.
beep is heard.
g. Press number button of channel in which
g. RT display blinks and "STO" is shown,
data is to be stored.
followed by the channel number in
which the data was stored.
h. Set fill device FUNCTION switch to OFF,
h. No response.
and disconnect fill device and fill cable
from RT.
i. Operational Check is complete.
17-5
