TM 11-5820-890-30-4
3-41. REPLACEMENT OF MOUNTING BRACKET. Continued
ITEM
ACTION
REMARKS
INSTALLATION
f. Mounting bracket (80)
g. Two hex nuts (28) and
flat washers (29)
h. Mounting hardware (83),
(84), and (86)
i.
Capacitor C1 (85)
j.
Diode CR1 (82)
Place replacement mounting bracket on
chassis (67) and aline mounting holes
with chassis studs.
Use 3/16-inch nutdriver. Install and tight-
These were removed in
en two retained hex nuts and flat washers
step d.
securing mounting bracket (80) to chassis
studs.
Use adjustable wrench. Install and tighten
These were removed in
retained nut (86) securing mounting post
step c.
(83) to mounting bracket (80). Use sol-
dering kit. Solder retained insulated stand-
off (84) to mounting bracket.
Install retained capacitor C1.
Refer to paragraph 3-40 for
installation procedures.
Install retained diode CR1.
Refer to paragraph 3-39 for
installation procedures.
Section VIl. PREPARATION FOR STORAGE OR SHIPMENT
3-42. GENERAL INFORMATION.
a.
Place all cables and adapters that are part of electronic equipment parts kit inside parts kit box. Secure
lid to box. Place box inside chest.
b.
Place all tools that are part of tool kit inside tool kit box. Close tool kit. Place tool kit inside chest.
c.
Place all test cables inside chest.
d. Close and secure chest inner lid.
e .
Attach and secure test adapter to chest.
3-111
