TM 11-5820-890-30-44-9.OPERATIONAL CHECK. ContinuedThe operational check is divided into steps. Each step verifies a particular function. Follow the instruction in the“Action” column. Check the response. If the response is correct, proceed with the next lettered step. When aStep has been completed, proceed with the next Step. A "No response" in the "Response" column means thatany response is not of interest.The switch settings for the test equipment are given in the “EQUIPMENT PRESETS” section of the test setupfigure. Set the test equipment switches to the indicated presets and then verify the settings. If a test response isincorrect, check the equipment settings and the test adapter cabling before going to a troubleshooting chart orreplacing a bad module.WARNINGHigh voltage (200 V dc) is present at mounting adapter connector J1. The large current capacityof the test power supply can cause personal injury. Use caution when connecting the test setupand taking measurements to avoid personal injury.Connect equipment as shown in figure 4-2 to perform the operational check of the mounting adapter.4-5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business