TM 11-5820-890-30-4
7-15. REPLACEMENT OF WIRING. Continued
ITEM
ACTION
REMARKS
INSTALLATION Continued
d.
e.
NOTES:
1. Using the wire stripper, strip 3.5 mm of insulation from one end of wire #006.
Using the wire stripper, strip 20.0 mm of insulation from other end of wire #006.
Using the soldering kit, tin both ends of wire #006. Insert the 20.0 mm end of wire
#006 through top terminals of filters FL1 and FL2 (20) and (21). Place a 12.0 mm
length of 16 gauge insulation sleeving on wire #006 between terminals of filters
FL1 and FL2 (20) and (21).
2. Using the wire stripper, strip 3.5 mm of insulation from one end of wire #031.
Using the wire stripper, strip 20.0 mm of insulation from other end of wire #031.
Using the soldering kit, tin both ends of wire #031. Insert the 20.0 mm end of wire
#031 through bottom terminals of filters FL1 and FL2 (20) and (21). Place a 12.0
mm length of 16 gauge insulation sleeving on wire #031 between terminals of
filters FL1 and FL2 (20) and (21).
3. Connect wire #032 to shields of wires #018, 019, and 024 going directly from
shield to shield. Cover all J5 pigtail connections with heat shrinkable insulation
sleeving. Cover exposed braid on end opposite pigtail connection of wires #018,
019, and 024 with heat shrinkable insulation sleeving. Cover all J3 and J4 con-
nections with 14 gauge insulation sleeving.
Wiring Continued
Shielded electrical
f. J5 connector (16)
cables
Using wire stripper, strip wires. Using
cotton swabs and alcohol, clean wires.
Using soldering kit, tin wires.
Prepare wires #018, 019, and 024 as
follows: Unbraid shielding from around
center conductor. Using cotton swabs
and alcohol, clean the shielding. Using
soldering kit, tin the shielding. Using wire
stripper, strip sleeving from center con-
ductor. Using cotton swabs and alcohol,
clean the center conductor. Using solder-
ing kit, solder wires as specified in the
wire list.
If applicable, install J5 connector.
Refer to paragraph 7-12
for installation instructions.
7-18
