TM 11-5820-890-30-4
13-37. REPLACEMENT OF E1 OR E2 BINDING POST. Continued
ITEM
ACTION
REMARKS
REMOVAL Continued
c.
d.
e.
Binding post (14) or (15)
wires
Hex nut, Iockwasher,
flat washer, and
nylon washer
Binding post
INSTALLATION
f.
g.
h.
i.
j.
Binding post
O-ring
(14) or (15)
(14) or (15)
nut, flat
washer, Iockwasher,
and nylon washer
Binding post (14) or (15)
wires
assembly (2)
13-38. REPLACEMENT OF J1
Tools:
Flat tip screwdriver
Torque screwdriver
Soldering kit
Expendable Supplies:
Silicone compound
Cotton swabs
References:
Tag location of all wires soldered to ter-
minals on rear of binding post. Use sol-
dering kit. Desolder each wire from the
binding post.
Use 5/16-inch wrench. Remove and
discard hex nut, Iockwasher, flat washer,
and nylon washer securing binding post
to chassis.
Remove and discard defective binding
post .
Obtain replacement binding post, hex nut,
Iockwasher, flat washer, and nylon washer.
Apply silicone compound to o-ring on re-
placement binding post.
Use 5/16-inch wrench. Install and hand
tighten replacement hex nut, Iockwasher,
flat washer, and nylon washer securing
binding post to chassis. Use torque
wrench, Torque nut to 6 in-lb.
Use soldering kit. Solder tagged wires to
terminals on rear of the binding post, and
remove wire tags.
Install retained heat sink assembly on
power supply adapter chassis (1).
CONNECTOR.
1 1/16-inch socket
Torque wrench
Socket wrench
Solder
Alcohol
Before and after soldering,
clean wires and binding
post terminals with alcohol
and cotton swabs.
Refer to paragraph 13-17
for heat sink installation.
Paragraph 13-17 for removal and installation of the heat sink assembly (8A1).
ITEM
ACTION
REMARKS
REMOVAL
a.
Heat sink assembly (2)
Remove and retain heat sink assembly
Refer to paragraph 13-17
from power supply adapter chassis (1).
for heat sink removal.
See figure 13-2.
13-58
