TB 11-5830-263-20-11
VIS CABLING INSTALLATION
Note
During installation, leave tiedown straps loose enough to adjust cable
slack and allow for easy adjustment of equipment. When installation is
complete, tighten and secure tiedown straps.
WARNING
MAKE SURE VEHICLE POWER SOURCE IS POSITIONED OFF OR
DISCONNECTED BEFORE INSTALLING CABLES.
a. MCS and Commander's FFCS Cabling Installation (Fig. 4-5)
1.
Secure connector P1 of the Radio R/T Cable Assembly (3) to the Radio A
connector on the MCS (6).
2.
Route the Radio R/T Cable (3) along the bulkhead wall, as shown in Figure
3.
Secure connector P2 of the Radio R/T Cable Assembly (3) to the Radio
Mounting Tray connector A4J3.
4.
Secure connector P1 of the Radio R/T Cable Assembly (3) to the Radio B
connector on the MCS (6).
5.
Route the Radio R/T Cable (3) along the bulkhead wall, as shown in Figure
6.
Secure connector P2 of the Radio R/T Cable Assembly (3) to the Radio
Mounting Tray connector A4J4.
7.
Secure connector P1 of the Power Cable Assembly (4) to the Power
connector on the MCS (6).
8.
Route the Power Cable Assembly (4) along the bulkhead wall as shown in
9.
Secure connector P2 of the Power Cable Assembly (4) to the Radio
Mounting Tray connector A4J2.
10. Secure vehicle cable 2W142-10 to the Alarm connector on the MCS (6).
11. Secure connector P1 of the Highway Cable Assembly (2) to the bottom
Station connector on the MCS (6).
12. Route the Highway Cable Assembly (2) along the ceiling/bulkhead wall, as
shown in Figure 4-5, until the Driver's FFCS (Figure 4-6) is reached.
13. Secure connector P1 of the Highway Cable Assembly (1) to the top Station
connector on the MCS (6).
14. Route the Highway Cable Assembly (1) along the bulkhead wall as shown
in Figure 4-5, until the Commander's FFCS (7) is reached.
15. Secure connector P2 of the Highway Cable Assembly (1) to the right side
Station connector of the Commander's FFCS (7).
(17 blank)/18
