TB 11-5830-263-20-14
VIS CABLING INSTALLATION
Note
During installation, leave loop clamps and tiedown straps loose enough
to adjust cable slack and allow for easy adjustment of equipment. When
installation is complete, tighten and secure clamps and tiedown straps.
WARNING
MAKE SURE VEHICLE POWER SOURCE IS POSITIONED OFF OR
DISCONNECTED BEFORE INSTALLING CABLES.
a. MCS and Loudspeaker Cabling Installation (Fig. 4-5)
1 . Secure connector P1 of the Radio R/T Cable Assembly (3) to the Radio A
connector on the MCS (10).
2 . Route the Radio R/T Cable (3) along the bulkhead wall, as shown in Figure
4-5, until the Radio Mounting Tray is
reached.
3 . Secure connector P2 of the Radio R/T Cable Assembly (3) to the Radio
Mounting Tray connector A4J3.
4. Secure connector P1 of the Power Cable Assembly (2) to the Power
connector on the MCS (10).
5 . Route the Power Cable Assembly (2) along the bulkhead wall as shown in
6. Secure connector P2 of the Power Cable Assembly (2) to the Radio
Mounting Tray connector A4J2.
7. Secure connector P1 of the Highway Cable Assembly (1) to the bottom
Station connector on the MCS (10).
8 . Route the Highway Cable Assembly (1) along the bulkhead wall, as shown
9. Secure connector P1 of the Highway Cable Assembly (1) to the top Station
connector on the MCS (10).
10. Route the Highway Cable Assembly (1) along the bulkhead wall as shown
11. Connect one end of Loudspeaker Cable Assembly (5) or (6) to the
Loudspeaker connector on the MCS (10).
(17 blank)/18