TM 11-5820-890-10-1
BRINGING ANOTHER STATION INTO THE NET Continued
h. Retrieve and sand hopset:
(1) Press LOAD.
(2) Enter channel number where hopset is stored.
(3) Press ERF.
(4) Confirm caller’s reception and storage of hopset.
(5) Tell caller to set CHAN to where hopset was stored.
(6) Confirm communication in FH mode.
(7) Repeat this step for additional hopset if they are needed.
i.
Tell new member to set FCTN to SQ ON (or normal operating position).
j.
Set FCTN to normal operating position.
CHANGING HOPSET IDENTIFICATION (ID)
Changing FH Hopset ID. When needed and authorized, the FH hopset ID can be
changed. The following procedure is to be performed only at the direction of the
NCS.
NOTE
When needed, it is possible to copy the hopset ID that is present
in one channel into another channel: Set FCTN to LD, press LOAD,
enter channel number where hopset is stored, press STO; then enter
the channel number in which it will be copied. If the hopset ID must
be changed, perform the following procedure.
a. Set FCTN to LD.
b.
Set MODE to
c.
Set CHAN to channel where the hopset ID is stored that needs to be changed.
d. Press FREQ (display will show old hopset ID).
e. Press CLR (display will show that the last
two digits have been cleared).
f.
Enter next to last digit of new hopset ID.
g. Enter last digit of new hopset ID.
NOTE
The old hopset ID will be cleared when step h has been done. If you
need to restore the original hopset ID, press FREQ, CLR, and enter
the last two digits of the original hopset ID.
h. Press STO (display will blink, and the new hopset ID is stored).
3-15
