TM 11-5820-890-10-3
CUE AND ERF This method of late net entry is to be used when the passive method did not work, or when you require
additional FH data to enter a net.
a
Load CUE frequency of the net to be entered Set
CHAN to CUE, and FCTN to LD.
b
Load MAN frequency of the net to be entered
Set CHAN to MAN, leaving FCTN at LD.
c
Set RF power to HI for manpack and PA for
vehicular radio.
d
Turn KY-57 OFF.
e
Set CHAN to CUE Press PTT for 4 - 5 seconds.
f
Then AT ONCE, turn KY-57 back ON and clear
alarm; then wait for a response.
g
Repeat after 15 seconds until CUE call is answered For each try, turn OFF KY-57 to send CUE and turn ON KY-57 to
receiver reply.
NOTE
CUE call goes through only when the net is quiet Because you do not know when the net is quiet, the
solution is to repeat your CUE call until you get an answer.
h
When your CUE call Is answered, wait for instructions from the NCS/Alt NCS regarding net entry and receiving an
ERF.
i
Once the ERF is stored, you are ready to enter the net.
2-46
