TM 11-5820-890-10-3
f
Tell members to set CHAN to where updated hopset was stored.
g
Set CHAN to new hopset channel.
•
If FH update is being done in CT, you (and members) must use the same COMSEC keys (in KY-57).
h
Contact members on new hopset.
i
Tell members to set FCTN to normal operating position.
BRINGING ANOTHER STATION INTO THE NET
When you receive a CUE call (on display), perform the following procedure to bring an outsider into your net. (If possible,
have alternate NCS or another designated station answer CUE call. If this is not possible, have alternate NCS control net
while NCS is out of the net to respond to the call.)
NOTE
CUE caller must have same COMSEC and FH data. If caller only has TRANSEC, ERF is
possible using PT.
Tell the present members of your net to stand by (have alternate NCS respond' to cue call or control net operations
while you are out of communication).
a
Set CHAN to CUE.
b
Respond to CUE caller.
c
Tell cue caller to set CHAN to MAN and stand by.
d
Establish communications on MAN channel and tell caller:
•
Set FCTN to LD.
•
Set MODE to FH.
•
Channel in which hopset is to be stored or hopset number.
•
Acknowledge when ERF has been received and stored.
e
Turn KY-57 to ON, RT MODE to FH-M , and RT CHAN to MAN.
f
Retrieve and send lockout set (if needed) Lockout set(s) must be sent before hopset:
(1) Press H-Ld.
(2) Press L.
(3) Enter the first digit of lockout set number.
(4) Press SEnd.
(5) Confirm caller's reception of lockout set.
(6) Repeat this step for additional lockout set(s) if they are needed.
3-16
