TM 11-5820-890-20-1
2.1.
ASSEMBLY INSTRUCTIONS. Continued
ITEM
ACTION
REMARKS
e.
Protective shipping covers
f. Battery (6)
Remove and discard plastic
shipping covers on connectors.
Position into battery box (4).
Position into RT-1523E.
9.
Battery box (4)
Set in place and firmly seat on RT
(7). Snap four hold-down latches
(5) closed.
If the rubber boots on the two-wire
interface posts are damaged,
replace by pulling the damaged
boots off and sliding new boots
on.
h. Antenna element (9)
i.
Manpack antenna
i.
Handset
k. RT
I. Field pack (11)
Lubricate threads with silicone
compound: then install on base.
Screw onto RT ANT connector.
Hand tighten until snug.
Lubricate connector O-ring (8)
with silicone compound. Connect
to RT AUD/DATA connector (10)
(J4). On HRCRD handset lubricate
both connector O-rings and
connect to RT AUD/DTA
connector and CY-8523C battery
box connector.
Place in backpack sleeve with
antenna on the left as shown.
Tighten straps (12) to secure RT.
2 - 2
