TM 11-5820-890-30-4
15-10. REPLACEMENT OF CONNECTOR CASE. Continued
ITEM
ACTION
REMARKS
REMOVAL Continued
h. Three (or two) screws
(25), flat washers (24),
and Iockwashers (23)
i. Filter mounting plate (22)
or FILTER EMl-CCA,
and wiring harness
j. Seal screw (11)
k. Connector case (12)
INSTALLATION
l.
m.
n.
o.
Connector case (12)
Seal screw (11)
Filter mounting plate (22)
or FILTER EMI-CCA,
and wiring harness
Three (or two) screws
(25), fiat washers (24),
and lockwashers (23)
Use cross tip screwdriver. Remove and
inspect three (or two) screws (25), flat
washers (24), and Iockwashers (23)
securing fitter mounting plate (22) or
FILTER EMI-CCA to connector case (12).
If damaged, obtain replacement.
Remove filter mounting plate (22) or
FILTER EMI-CCA, and wiring harness from
connector case (12). if damaged,
obtain replacement.
Use flat tip screwdriver. Remove seal
screw (11) from connector case (12),
and inspect it. If damaged, obtain
replacement.
Discard defective connector case (12).
Obtain replacement connector case (12).
Use fiat tip screwdriver. Install and hand
tighten seal screw (11) in connector
case (12).
Place filter mounting plate (22)
or FILTER EMI-CCA, and wiring
harness in connector case (12).
Use cross tip screwdriver. Install and
hand tighten three (or two) screws (25),
fiat washers (24), and Iockwashers (23).
NOTE
For versions with a
FILTER EMI-CCA there
will be hardware for only
two holes after removal
of ground lug in step g.
NOTE
For versions with a
FILTER EMI-CCA two
sets of hardware are
installed on the side of
the CCA that contains
two holes.
15-8
