TM 11-5820-890-30-4
16-11. REPLACEMENT OF J1, J2, J3, OR J4 CONNECTOR. Continued
ITEM
ACTION
REMARKS
INSTALLATION Continued
f. Connector terminals
Use soldering kit. Solder wires to correct
terminals of connector. If necessary, slide
insulation sleeving down over connection,
and apply heat to it until
around the connection.
it shrinks tight
g. Tiedown straps (13)
Replace any tiedown straps (13) that
were removed.
NOTE
Ensure each wire
lation sleeving on
if necessary, and
has insu-
it
each wire is placed through
mounting hole in connector
case (12). While soldering
wires, attach heat sink to
bare wire between insula-
tion sleeving and terminal.
Before and after soldering,
clean wires and terminals
with cotton swabs
and alcohol.
h. Eight screws (5)
Use cross tip screwdriver. Install and
and lockwashers (6)
hand tighten eight screws (5) and
Iockwashers (6) securing access
cover (1) to connector case (12).
Use torque screwdriver. Torque
screws to 8 to 10 in-lb.
If a screw is not stripped
but will not tighten, refer
to paragraph 15-16 for
replacement of its threaded
screw insert (if present).
If a tapped hole is defec-
tive, refer to paragraph
15-10 for replacement of
the connector case. (12).
15-12. REPLACEMENT OF J5
Tools:
flat tip screwdriver
Adjustable wrench
Expendable supplies:
SiIicone compound
Alcohol
References:
CONNECTOR.
Soldering kit
Cotton swabs
Solder
Paragraph 15-16 for removal and installation of threaded screw inserts.
ITEM
ACTION
REMARKS
REMOVAL
a. Electrical connector
assembly (9A1)
Set on work surface with J5 connector
(16) toward you, See figure 15-3.
15-11
