TM 11-5820-890-30-4
15-9. REPLACEMENT OF ACCESS COVER. Continued
ITEM
ACTION
REMARKS
REMOVAL Continued
b. Two protective caps (2)
c. Four
d. Four
spanner nuts (3)
electrical connector
retainers (4)
e. Access cover (1)
INSTALLATION
f.
g.
h.
i.
j.
k.
Access cover (1)
Four o-rings
J1 through J4 connectors
(7) through (10)
Four electrical connector
retainers (4)
Remove and inspect two protective caps
(2) from J4 and J2 connectors (9) and
(10). If damaged, obtain replacement.
We spanner wrench with 1-1/4-inch spanner
wrench attachment. Remove and Inspect
four spanner nuts (3) from J1 through J4
connectors (7) through (10). If damaged,
obtain replacement.
Remove and inspect four electrical connector
retainers from four connectors. If damaged,
obtain replacement.
Remove and discard defective access cover (1).
Four spanner
nuts (3)
Use spanner wrench. Install and hand
tighten four spanner nuts (3) securing
four connectors to access cover (l).
Use torque wrench and 1-1/4-inch
spanner wrench attachment. Torque
nuts to 100 in-lb.
Obtain replacement access cover (1).
Coat o-rings of four connectors (7)
through (10) with silicone compound.
Install four connectors in four connector
holes in access cover (1).
Install four electrical connector retainers
(4) on four connectors.
If a screw is not stripped
but will not tighten, refer
to paragraph 15-16 for
replacement of its threaded
screw insert (if present).
If a tapped hole is defec-
tive, refer to paragraph
15-10 for replacement of
the connector case. (12).
Eight screws
and Iockwashers (6)
(5)
Use cross tip screwdriver. Install and
hand tighten eight screws (5) and
Iockwashers (6) securing access
cover(l) to connector case (12).
Use torque screwdriver. Torque
screws to 8 to 10 in-lb.
l. Two protective caps (2)
Install two protective caps (2) on J4
and J2 connectors (9) and (10).
15-6
