TM 11-5820-890-30-4
8-12. REPLACEMENT OF BATTERY BOX COVER.
Tools:
Cross tip screwdriver
Pocket knife
References:
Paragraph 8-21 for removal and installation of dampening tape gasket.
ITEM
ACTION
REMARKS
REMOVAL
a. Two battery box cover
latches (32)
b. Four screws (11), flat
washers (13), and lock-
washers (12)
c. Dampening tape
gaskets (3)
d. Battery box cover (1)
INSTALLATION
e. Battery box cover (1)
f. Dampening tape
gaskets (3)
g. Battery box cover (1)
h. Two battery box cover
latches (32)
i.
Two battery box cover
latches (32)
Release two twist lock latches securing
battery box cover (1) to battery box
case (15). See figure 8-3.
Use cross tip screwdriver. Remove and
retain two screws (11 ), flat washers (13),
and Iockwashers (12) securing each latch
(32) to battery box cover (1). Remove
and retain two latches (32).
Remove and retain.
Discard.
Obtain replacement.
Install.
Place on battery box case (15).
Refer to paragraph 8-21 for
removal procedures.
Refer to paragraph 8-21 for
installation procedures.
NOTE
If replacing latch/strike
assembly equipped with
battery box cover retaining
ring (24), insure retaining
ring is properly positioned
under latch/strike assembly
before proceeding to
step h.
NOTE
Position two retained latches on cover (1). Do not over tighten screws
Use cross tip screwdriver. Install two re-
securing latches to cover.
tained screws (11), flat washers (13),
and Iockwashers (12) securing latches to
battery box cover (1).
Fasten two twist lock latches securing
battery box cover (1) to battery box
case (15).
8-9
