TM 11-5820-890-30-4
8-16. REPLACEMENT OF ACCESS COVER. Continued
ITEM
ACTION
REMARKS
REMOVAL Continued
c. Bus wires
Use soldering kit. Desolder bus wires from
binding posts (28).
d. Two-wire transient protec-
Use cross tip screwdriver. Remove and re-
tion CCA (26)
tain four screws (9), Iockwashers (8), and
flat washers (7) securing two-wire transient
protection CCA (26) to access cover (27).
Remove and retain.
e. Access cover gasket (25)
Remove and retain.
f. Two binding posts (28)
Use 5/16-inch open end wrench. Remove
and retain two nuts, Iockwashers, and flat
washers securing binding posts to access
cover. Remove and retain.
g. Access cover
INSTALLATION
h. Access cover
(27)
(27)
i. Two binding posts
(28)
j.
Access cover gasket (25)
k. Two-wire transient protec-
tion CCA (26)
l.
Bus wires
m. Two-wire transient protec-
tion CCA (26)
n. Access cover (27)
Remove and discard.
Obtain replacement.
Position two retained binding posts to re-
placement access cover (27). Use torque
wrench and 5/16-inch socket. Install two
retained nuts, Iockwashers, and fiat wash-
ers securing binding posts to access cov-
er. Torque screws to 5 to 7 in-ib.
install retained gasket to access cover.
Position retained CCA to access cover.
Use cross tip screwdriver. Install four re-
tained screws (9), Iockwashers (8), and
flat washers (7) securing CCA to access
cover.
Use soldering kit. Position and solder two
retained bus wires to E4 and binding post
and to E5 and binding post.
Use soldering kit. Position and solder three
tagged wires to terminals E1 thru E3.
Position access cover to battery box case
(15). Using torque screwdriver tighten
five captive screws (31) securing access
These were removed in
step f.
This was removed in
step e.
These were removed in
step d.
NOTE
Before and after soldering,
clean wires and solder
joints with alcohol and
cotton swabs.
These were removed in
step a.
cover (27) to battery box case (15). Torque
screws to 5 in-lb.
8-13
