TM 11-5820-890-30-4
8-17. REPLACEMENT OF BINDING POSTS. Continued
ITEM
ACTION
REMARKS
INSTALLATION Continued
k. Access cover (27)
8-18. REPLACEMENT OF J1
Tools:
Cross tip screwdriver
Soldering kit
Expendable Supplies:
Sealing compound
Cotton swabs
Use torque screwdriver. Position and
tighten five captive screws (31) securing
access cover to battery box case (15).
Torque screws to 5 in-lb.
CONNECTOR.
Torque screwdriver
Heat sink
Soldering aid
Alcohol
Solder
ITEM
ACTION
REMARKS
REMOVAL
a. Battery box case (15)
b. Wires
c. O-ring (33) and shielding
gasket (19)
d. J1 connector (34)
INSTALLATION
e. J1 connector (34)
f. O-ring (33) and shielding
gasket (19)
g. Wires
h. J1 connector (34)
i. Battery box case (15)
Use cross tip screwdriver. Remove and
retain two screws (21) securing J1 con-
nector to case. Pull J1 connector from
case.
Slide insulation sleeving away from sol-
der joints. Use soldering kit. Tag and
desolder wires from J1 connector.
Remove and retain. Inspect for damage.
Replace as required.
Discard.
Obtain replacement.
Coat O-ring with sealing compound. Install
shielding gasket and O-ring to replacement
J1 connector.
Use soldering kit. Position and solder
tagged wires to J1 connector. Remove
wire tags.
Position connector into battery box
case (15).
Use torque screwdriver. Install two retain-
ed screws (21) securing connector to
case. Torque screws to 8 to 10 in-lb.
These were removed in
step c.
NOTE
Before and after soldering,
clean wires and solder
joints with alcohol and
cotton swabs.
NOTE
Ensure keyway is toward
seal screw.
These were removed in
step a.
8-15
