TM 11-5820-890-30-4
13-25. REPLACEMENT OF J2 CONNECTOR. Continued
ITEM
ACTION
REMARKS
INSTALLATION
g.
Connector (1) and
Obtain replacement connector and
Iockwasher
Iockwasher.
h.
Connector (1) wires
Use soldering kit. Solder tagged wires
correct connector pins, and remove
wire tags.
i.
O-ring
j. Spanner nut
and Iockwasher
k.
Rear access cover (2)
l. 12 captive
screws (3)
Apply silicone compound to o-ring on
replacement connector.
to
Use 1 5/16-inch spanner wrench. Install
and hand tighten retained spanner nut
and replacement Iockwasher securing
the connector to power supply adapter
chassis. Use torque wrench and socket
wrench spanner attachment. Torque
nut to 90 in-lb.
Position retained rear access cover on
the power supply adapter chassis.
Use flat tip screwdriver. Install and hand
tighten the 12 captive screws securing
the rear access cover to the power sup-
ply adapter chassis. Use torque screw-
driver. Torque screws to 8 to 10 in-lb.
Before and after soldering,
clean wires and connector
pins with alcohol and
cotton swabs.
These were removed in
steps d and e.
13-41
