TM 11-5820-890-30-4
13-23. REPLACEMENT OF P1 CONNECTOR. Continued
ITEM
ACTION
REMARKS
INSTALLATION
h.
Connector (9)
i.
Connector (9) wires
j.
Connector (9) and
connector retaining
plate (11 )
k. Four screws (10)
l.
Rear access cover (2)
m. 12 captive
screws (3)
Obtain replacement connector.
Use soldering kit. Solder tagged wires to
correct connector pins, and remove
wire tags.
Position replacement connector and
retained connector retaining plate in
rear access cover.
Apply sealing compound to threads of
four retained screws. Use flat tip screw-
driver. Install and hand tighten four
screws securing the connector to the
rear access cover. Use torque screw-
driver. Torque screws to 90 in-lb.
Position retained rear access cover on
the power supply adapter chassis.
Use flat tip screwdriver. Install and hand
tighten the 12 captive screws securing
the rear access cover to the power supply
adapter chassis. Use torque screwdriver.
Torque screws to 8 to 10 in-lb.
Before and after soldering,
clean wires and connector
pins with alcohol and
cotton swabs.
These were removed in
step d.
13-38
