TM 11-5820-890-30-4
13-22. REPLACEMENT OF J5 CONNECTOR. Continued
ITEM
ACTION
REMARKS
INSTALLATION
h. Connector (6) and
Obtain replacement connector and
Iockwasher
Iockwasher.
i.
Connector (6) wires
Use soldering kit. Solder tagged wires
correct connector pins, and remove
wire tags.
j.
O-ring
Apply silicone compound to o-ring on
replacement connector.
k. Hex nut and
Use 1 1/16-inch socket wrench, Install
Iockwasher
and hand tighten retained hex nut and
replacement Iockwasher securing the
connector to the access cover. Use
torque wrench and 1 1/16-inch socket.
Torque nut to 70 in-lb.
l.
Rear access cover (2)
Position retained rear access cover on
the power supply adapter chassis.
m. 12 captive
Use flat tip screwdriver. Install and
screws (3)
hand tighten the 12 captive screws
securing the rear access cover to the
power supply adapter chassis. Use
torque screwdriver. Torque screws to
8 to 10 in-lb.
Install the protective cap on the
connector.
n.
Protective cap (7)
to
Before and after soldering,
clean wires and connector
pins with alcohol and
cotton swabs.
These were removed in
steps e and f.
13-36
