TM 11-5820-890-10-1
a.
b.
ECCM Fill Device Connected to RT
Make sure that the ECCM fill device is loaded. If the ECCM fill device needs
to be filled, see pages 4-13 thru 4-15.
Set ECCM fill device function switch to OFF.
CAUTION
ALWAYS USE A FILL CABLE TO CONNECT FILL DEVICE TO RT. EQUIP-
MENT DAMAGE MAY RESULT IF A FILL CABLE IS NOT USED.
Connect ECCM fill device to RT connector AUD/FILL using fill cable.
Set RT FCTN to LD.
Set RT MODE to FH.
Set CHAN to where data is to be loaded (NCS will direct you).
Set ECCM fill device select switch to position
containing the desired data.
Set ECCM fill device function switch to ON.
Press LOAD. Display will cycle as shown,
and a beep is heard.
j.
Press STO. Display will blink and show
"STOL" followed by the first digit of the
data.
k. Change ECCM fill device select switch to
position containing data desired next.
l.
Press LOAD. Display will cycle as
shown, and a beep is heard.
m. Press STO; then press the number
button of the channel in which the
data is to be stored. Display will
blink and show "STO" followed by
the channel number in which the
data was stored.
LOADING FH DATA. Check with NCS or SOI for required FH data.
2-36
