TM 11-5820-890-30-4
14-31. REPLACEMENT OF BATTERY TRAY CHASSIS. Continued
ITEM
ACTION
REMARKS
v .
INSTALLATION Continued
A2 connector
board CCA (13) and
Install to chassis.
P1 connector (16)
W. VR1 zener diode (3)
Install to chassis.
X. A1 battery tray CCA (8)
Install to chassis.
y. U1
z. E1
voltage regulator (10)
terminal lug (12)
aa. Mounting plate
ab. Four catch strikes
ac. identification plate
(7)
(8)
ad. Battery box gasket (8)
ae. Seal screw (6)
Install to chassis.
Install screw and flat washer securing
terminal lug to chassis.
Install retained mounting plate on battery
tray subassembly.
Use cross tip screwdriver. Install eight
retained screws, fiat washers, and lock-
washers (6) securing four catch strikes
(7) to chassis. See figure 14-4.
Obtain replacement identification plate.
Peel backing from plate. Place plate on
chassis. Apply downward pressure on
plate to form a seal between it and
chassis. See figure 14-4.
Obtain replacement battery box gasket.
Peel backing from gasket, place gasket
on chassis. Apply downward pressure
on gasket to form a seal between it and
chassis. See figure 14-3.
Obtain replacement seal screw, install
and hand tighten seal screw, securing
it to chassis. Use torque screwdriver.
Torque screw to 20 in-lb.
Refer to paragraph 14-21
for installation of A2 con-
nector board CCA and P1
connector. Ensure that
27 pins of P1 connector
(16) are securely connect-
ed to A2 connector board
CCA (13).
Refer to paragraph 14-23
for installation of VR1 zener
diode.
Refer to paragraph 14-20
for installation of Al battery
tray CCA.
Refer to paragraph 14-25
for installation of U1 voltage
regulator.
Refer to paragraph 14-19
for installation of mounting
plate.
Refer to paragraph 14-32
for installation of battery
box gasket.
14-36
