TM 11-5820-890-30-4
14-27. REPLACEMENT OF WIRES. Continued
ITEM
ACTION
REMARKS
INSTALLATION Continued
e. Replacement wire(s)
f. Connector(s) and
terminal lug(s) (3)
g. Tiedown strap(s) (1)
h. J1 connector
i.
Mounting plate
14-28.
Tools:
REPLACEMENT
Tin ends of replacement wire(s).
Use long nose pliers and soldering equip-
ment. Attach and solder replacement
wire (s) to existing wire(s), connector(s),
and/or terminal lug(s).
Install replacement tiedown strap(s)
on wiring.
If removed, install J1 connector.
Install retained mounting plate on battery
tray subassembly.
OF DS1 LAMP HOLDER.
Cross tip screwdriver
Soldering kit
Socket wrench
9/16-inch socket
Expendable Supplies:
Solder
Alcohol
References:
Paragraph 14-19 for removal and installation of mounting plate.
Before and after soldering,
clean wire (s), connector(s),
and terminal lug (s) with
alcohol and cotton swabs.
Refer to paragraph 14-24
for installation of J1 connec-
tor.
Refer to paragraph 14-19
for installation of mounting
plate.
Long nose pliers
Torque wrench
Cotton swabs
Paragraph 14-21 for removal and installation of A2 connector board and P1 connector assembly.
ITEM
ACTION
REMARKS
REMOVAL
a. Mounting plate
Remove and retain.
Refer to paragraph 14-19
for removal of mounting
plate.
b. Light lens, lamp, and
Unscrew and remove light lens, lamp,
o-ring
and o-ring from DS1 lamp holder (14).
Inspect them for damage. If damaged,
obtain replacement. See figure 14-5.
c. DS1 lamp holder (14)
Tag the destination of each wire on DS1
wires
lamp holder. Use long nose pliers and
soldering kit. Desolder tagged wires from
terminals on lamp holder. See figures
14-5 and 14-6.
d. A2 connector board and
Remove assembly from chassis without
Refer to paragraph 14-21
P1 connector assembly
resoldering wires.
for removal of assembly.
14-31
