TM 11-5820-890-30-4
14-31.
Tools:
REPLACEMENT OF BATTERY
Flat tip screwdriver
Cross tip screwdriver
Spanner wrench
1-1/8-spanner wrench adapter
Expendable Supplies:
Silicone compound
References:
TRAY CHASSIS.
Torque screwdriver
Socket wrench
Torque wrench
Pocket knife
Paragraph 14-19 for removal and installation of
Paragraph 14-20 for removal and installation of
Paragraph 14-21 for removal and installation of
Paragraph 14-22 for removal and installation of
Paragraph 14-23 for removal and installation of
Paragraph 14-24 for removal and installation of
Paragraph 14-25 for removal and installation of
Paragraph 14-28 for removal and installation of
Paragraph 14-29 for removal and installation of
Paragraph 14-30 for removal and installation of
Paragraph 14-32 for removal and installation of
3/8-inch open-end wrench
5/16-inch socket
9/16-inch socket
7/8-inch socket
mounting plate assembly.
A1 battery tray CCA.
A2 connector board CCA and P1 connector.
R1 resistor.
VR1 zener diode.
J1 connector.
U1 voltage regulator.
DS1 lamp holder.
seal screw.
S1 pushbutton switch.
battery box gasket.
ITEM
ACTION
REMARKS
REMOVAL
a. Mounting plate
b. A1 battery tray CCA (8)
c. J1 connector (5)
d. U1 voltage regulator (10)
e. A2 connector board CCA
(13) and P1 connector (16)
f. Light lens
g. DS1 lamp holder (14)
Remove and retain.
Remove and retain. See figure 14-5.
Remove and retain.
Remove and retain.
Remove and retain.
Remove light lens from DS1 lamp holder
(14). Inspect it for damage. If damaged,
obtain replacement.
Remove and retain.
Refer to paragraph 14-19
for removal of mounting
plate.
Refer to paragraph 14-20
for removal of Al battery
tray CCA.
Refer to paragraph 14-24
for removal of J1 connec-
tor.
Refer to paragraph 14-25
for removal of U1 voltage
regulator.
Refer to paragraph 14-21
for removal of A2 connec-
tor board CCA and P1 con-
nector.
Refer to paragraph 14-28
for removal of DS1 lamp
holder.
14-34
