TM 11-5820-890-30-4
2-36. REPLACEMENT OF IMPEDANCE MATCHING NETWORK (1A1).
Tools:
Flat tip screwdriver
Torque screwdriver
Module extractor
Round nose pliers
References:
Paragraph 2-33 for use of module extractor.
Paragraph 2-34 for removal and installation of
Figure 2-13 for module and cable locations.
RT covers.
ITEM
ACTION
REMARKS
REMOVAL
a.
RT bottom cover
b. RF cable (1W1)
c.
RT top cover
d. RF cable
e.
Impedance matching network
INSTALLATION
f.
RF cable
g.
Impedance matching network
h.
RF cable
i. RT top cover
j.
RF cable (1W1)
k. RT bottom cover
Remove.
Use round nose pliers. Remove
from impedance matching
network.
Remove.
Use round nose pliers. Remove
end connected to impedance
matching network.
Remove.
Hold away from module location.
Check connector location and
place in card guide. Press down
to fully seat.
Attach to connector on imped-
ance matching network.
Install.
Attach to impedance matching
network.
Install.
Refer to paragraph 2-34 for
removal of bottom cover.
Refer to paragraph 2-34 for
removal of top cover.
See figure 2-13 for cable
location.
Refer to paragraph 2-33 for use
of module extractor.
Refer to paragraph 2-34 for
installation of top cover.
Refer to paragraph 2-34 for
installation of bottom cover.
2-206
