TM 11-5820-890-30-4
2-37. REPLACEMENT OF POWER
Tools:
Cross tip screwdriver
Module extractor
References:
SUPPLY (1A3).
Flat tip screwdriver
Paragraph 2-33 for use of module extractor.
Paragraph 2-34 for removal and installation of RT covers.
Figure 2-13 for module locations.
Figure 2-14 for screw locations.
Torque screwdriver
ITEM
ACTION
REMARKS
REMOVAL
a.
RT bottom cover
b. Two screws
c.
RT top cover
d. Power supply
INSTALLATION
e.
Power supply
f.
Two screws
g. RT bottom cover
h. RT top cover
Remove.
Use cross tip screwdriver.
Remove and retain two screws
securing power supply.
Remove.
Remove.
Check connector location and
insert power supply. Press down
to fully seat.
Use cross tip screwdriver. Install.
Install.
Install.
Refer to paragraph 2-34 for
removal of bottom cover.
See figure 2-14 for screw
locations.
Refer to paragraph 2-34 for
removal of top cover.
Refer to paragraph 2-33 for use
of module extractor.
These were removed in step b.
Refer to paragraph 2-34 for
installation of bottom cover.
Refer to paragraph 2-34 for
installation of top cover.
2-207
