TM 11-5820-890-30-4
13-21. REPLACEMENT OF J3 OR J4 CONNECTOR. Continued
ITEM
ACTION
REMARKS
INSTALLATION
h. Connector (4) or
and Iockwasher
i.
Connector (4) or
wires
j.
O-ring
(8)
(8)
k. Hex nut and
Iockwasher
l.
Rear access cover
m. 12 captive
screws (3)
n.
Protective cap (5)
(2)
Obtain replacement connector and
Iockwasher.
Use soldering kit. Solder tagged wires
correct connector pins, and remove
wire tags.
Apply silicone compound to o-ring on
replacement connector.
to
Use 7/8-inch socket wrench. Install and
hand tighten retained hex nut and re-
placement Iockwasher securing the con-
nector to the access cover. Use torque
wrench and 7/8-inch socket. Torque nut
to 60 in-lb.
Position retained rear access cover on
the power supply adapter chassis.
Use flat tip screwdriver. Install and hand
tighten the 12 captive screws securing
the rear access cover to the power supply
adapter chassis. Use torque screwdriver.
Torque screws to 8 to 10 in-lb.
Install the protective cap on the
connector.
Before and after soldering,
clean wires and connector
pins with alcohol and
cotton swabs.
These were removed in
steps e and f.
This was removed in
step c.
13-34
