TM 11-5820-890-30-4
13-40. REPLACEMENT OF POWER SUPPLY ADAPTER CHASSIS ASSEMBLY. Continued
ITEM
ACTION
REMARKS
REMOVAL Continued
l.
m.
n.
o.
p.
q.
r.
s.
t.
u.
v.
Power supply adapter
chassis assembly (1)
Binding post (5) wires
Two hex nuts, lockwash-
ers, flat washers, and
nylon washers
Binding posts (5)
Light lens
Lamp
Lamp holder (6) wires
Hex nut and Iockwasher
Lamp holder (6)
Circuit breaker (7) wires
Hex nut, switch plate,
and lock ring
w. Circuit breaker (7)
Set upside down on work surface with
front toward you. See figure 13-10.
Tag location of all wires soldered to ter-
minals of the E1 and E2 binding posts.
Use soldering kit. Desolder each wire
from the terminals.
Use 5/16-inch wrench. Remove and in-
spect two hex nuts, flat washers, and
nylon washers securing binding posts
on the chassis, If damaged, obtain
replacement. Discard lockwashers.
Remove and retain.
Remove light lens from DS1 lamp holder
(6) and inspect for damage. If damaged,
obtain replacement.
Remove lamp from DS1 lamp holder (6)
and inspect for damage. If damaged,
obtain replacement.
Tag location of all wires soldered to ter-
minals of the lamp holder. Use soldering
kit. Desolder each wire from the terminals.
Use 9/16-inch wrench. Remove and
inspect hex nut securing lamp holder
on the chassis. If damaged, obtain
replacement. Discard Iockwasher.
Remove and retain.
Tag location of all wires soldered to CB1
circuit breaker terminals. Use soldering kit.
Desolder each wire from the circuit breaker.
Use adjustable wrench. Note orientation
of circuit breaker. Remove and inspect
hex nut, switch plate, and lock ring se-
curing circuit breaker on the chassis.
If damaged, obtain replacement.
Remove and retain.
13-66
