TM 11-5820-890-30-4
14-19. REPLACEMENT OF MOUNTING PLATE.
Tools:
Flat tip screwdriver
Torque screwdriver
References:
Paragraph 14-33 for removal and installation of threaded screw inserts.
ITEM
ACTION
REMARKS
REMOVAL
a. Battery tray assembly
b. Eight captive screws (4)
and flat washers (5)
c. Mounting plate (2)
d. Battery tray gasket (3)
INSTALLATION
e. Mounting plate (2)
f. Battery tray gasket (3)
g. Mounting plate (2)
and battery tray
subassembly (1)
h.
Eight captive
screws (4) and flat
washers (5)
Set on work surface with mounting
plate (2) on top. See figure 14-4.
Use flat tip screwdriver. Fully loosen
and inspect eight captive screws and
flat washers securing mounting plate
(2) to battery tray subassembly (1).
If damaged, obtain replacement.
Remove and discard.
Inspect battery tray gasket (3). If dam-
aged, obtain replacement.
Obtain replacement mounting plate.
Position to battery tray subassembly (1).
Position replacement mounting plate (2)
to retained battery tray subassembly (1).
Use torque screwdriver. Install eight cap-
tive screws and flat washers securing
replacement mounting plate (2) to re-
tained battery tray subassembly (1).
Torque screws to 8 to 10 in-lb.
Inspect each screw and its
threaded screw insert to
determine if any is defec-
tive. If a screw is not
stripped but will not tighten,
refer to paragraph 14-33
for removal and replace-
ment of threaded screw
inserts.
14-20
