TM 11-5820-890-30-4
14-20. REPLACEMENT OF BATTERY TRAY CIRCUIT CARD ASSEMBLY (12A1A1). Continued
ITEM
ACTION
REMARKS
REMOVAL Continued
d. Six screws, flat washers,
and Iockwashers (7)
e. A1 battery tray CCA (8)
INSTALLATION
f. A1 battery tray CCA (8)
g. Six screws, flat washers,
and Iockwashers (7)
h. A1 battery tray CCA (8)
i.
Mounting plate
Figure 14-5.
See figure 14-5. Use cross tip screw-
driver. Remove and inspect six screws,
flat washers, and Iockwashers securing
Al battery tray CCA (8) to chassis. If
damaged, obtain replacement.
Remove and discard.
Obtain replacement A1 battery tray CCA
and place it on the chassis.
Use cross tip screwdriver. Install six re-
tained screws, flat washers, and lock-
washers securing A1 battery tray CCA
(8) to chassis.
Use long nose pliers and soldering kit.
Attach and solder 20 tagged wires to
17 E-terminals on A1 battery tray CCA,
and remove wire tags.
Install retained mounting plate on battery
tray subassembly.
These were removed in
step d.
Before and after soldering,
clean wires and E-terminals
with alcohol and cotton
swabs.
Refer to paragraph 14-19
for installation of mounting
plate.
Battery Tray Subassembly Without Mounting Plate and Battery Tray Gasket.
14-22
