TM 11-5830-263-10
e. Set PROGRAM switch to RADIO. Display shows 4 C r t .
Depress CHANGE button until C changes to A (display will scroll through D, E, F
then A). Display will show 4 A * * .
f. Set PROGRAM switch to FUNCTION. Depress CHANGE button until
display shows 4 A r t .
I. Turn PROGRAM switch to the STORE position momentarily and release.
4 A r t is stored to program memory.
c. VERIFYING PROGRAMMING INFORMATION
NOTE
Utilizing the VIEW mode on the PROGRAM switch
enables the programmer/operator to verify the level
of radio access for each crewstation/FFCS for the
selected program (PROG 1, PROG 2, PROG 3).
Though the same function can be accomplished
utilizing the CHANGE button while alternately
setting the PROGRAM switch on STATION and
RADIO the VIEW mode is quicker and not subject
to operator error.
1. Set PROGRAM switch to VIEW and observe display. If programming
has been correctly accomplished the display should show in sequence
P 1
, v i e w, 1 A r *, 2 A r t, 3 A r t,
3 B r t, 4 A r t, 4 C r t.
2. If programming is correct set PROGRAM switch on SYSTEM and begin
communication operations.
3. If programming is incorrect refer to para 2.10.2. to make changes to
existing programming.
4. If error messages occur upon placing the PROGRAM switch in the
SYSTEM position refer to the troubleshooting chart in Chapter 3 or higher level
maintenance.
2.10.2 Changes To Existing Programming
Making changes to existing programming involve the same procedures
demonstrated for programming the MCS (refer to para. 2.10.1(b)). The SYSTEM
switch is set on the specific program requiring change (PROG 1, PROG 2,
PROG 3), while the PROGRAM switch is set on STATION/RADIO/FUNCTION
and used in conjunction with the CHANGE button. Figure 2-19 shows the
procedures required when making a change to the programming accomplished in
radio B (current capability shows FFCS 2 receiving and transmitting on radio A
only).
2 - 27
